Care sunt noutăţile

Ce este nou în versiunea actuală a GOM Software?


Smart Teach

If the CAD or single elements change, the measurement positions are automatically updated with “Smart Teach”. In addition, the user is much more supported in achieving a stable measuring sequence in a shorter time by advanced display options of the project status. This is also further emphasized by the introduction of scanning templates for setting application-specific parameters prior to the measuring procedure. For complex or shiny surfaces that require a specific measuring angle, these improvements lead to a significant increase in efficiency.


Surface Inspection

If a defect is detected by several tools, the found defects can be merged into one representation. This means that the audit score no longer depends on the number of tools used, but on the quality of the part. In addition, the new software offers the possibility of testing a part against a limit sample. This enables a simple actual-actual comparison, and known, accepted defects are not displayed in the result representation. With advanced functions for the defect analysis, there is now also a convenient way to find and analyze skid lines, expanding the application range of this solution.


Virtual Clamping

With a new module that supplements the ATOS and GOM Inspect Professional software packages, sheet metal and injection-molded parts can be virtually clamped and thus measured without complex clamping devices. An innovative, FEM-based algorithm makes it possible to compute the constrained state of the part. This virtual clamping procedure is fully integrated into the GOM workflow; there is no need to leave the software interface.



Details and registration for training courses at www.gom.com/events/training.